FX-61 Hobbyking Phantom FPV

Last year bought this plane for my fpv’ng but due to it large size it hard to bring this beast around, plane will be given away for free to anyone in malaysia if you are willing to pickup it up from me :)

Hobbyking does not seem to re-stock the plane anymore most probably it has been replaced by FX-71 buffalo or Go Discovery wing

My current setup of the wing are

– NTM 3536 1400KV 600Watt motor with 60A ESC

– 10×6 aeronaut carbon cam

– 4200mAh for short range and 10,000mAh battery 3S

– MG929 hobbyking 12g servo

– PV0420 640tvl with 200mw bevrc 1.3ghz video transmitter

– BEVRC RX with 5 turn Helical (10km record so far with 200mw)

– Dominator Goggle

– Storm OSD with RTH

Kits will include NOTHING only bare kits no servo or anything

some picture of it current condition

PhotoGrid_1392971964140

not pretty but still flyable :D, here was previously assemble with OSD

20130609_170041 20130622_091642 20130622_133542

last video FPV around Puncak jalil with inverted landing at the end :D

Small Desktop CNC Machine

Small Desktop CNC Machine

Usually can get it cheap on ebay, good for pcb isolation milling and small engraving and cutting, as to date I have cut acrylic,fiber glass and carbon fiber without any problem, I’m using cambam for gcode generator (quite a while to learn how to use cambam) and mach3 to run the machine, only downside of the machine is it small work space but with the right tools you can upgrade the Y,X axis, Since I’m using notebook and lack of paralel printer port I have no choice to use a USB motion controller (UC100: cncdrive.com/UC100.html ) which enable mach3 to be use with USB port quite expensive but worth every penny

20131217_232453 20131218_211319 20140205_222018 20140205_222026 20140205_22204220140212_004248