Repetier-Host Slic3r config

Request by my reader here is my Slic3r setting that I use with Repetier-Host

Repetier-Hosthttp://reprap.org/wiki/Repetier-Host

This is what I used to print this:

20140612_012350Slic3r Setting, only for the important stuff

Layer And Perimeters:

LnPInfill

Infill

Speed

Speed

Advanced

Adv

last but not least my Extruder setting, this you need to probably fine tune to your printer

Extruder

 

 

 

MendelMax 1.5 Calibration Part 2 + extra

Here is my final print,

10% infill 0.3 layer

100mm/s retract speed

3mm retract lenght

couldt be more happy with the result  :cayo:

20140612_012350

In addition to that I added a servo for auto bed leveling :) work quite nice I must say but problem is the servo is to far out to the front, I will need to print a new x-carriage so I can put the servo to the side so it can cover a lot more bed surface

20140612_131648