Finally a fully functional Reprap 3D printer, got my crucial part for cleaning up my wiring which is a acrylic plate, cleaned up my wiring nice and tidy now :), for previous post
Blomker Mendelmax 1.5 3D Printer BuildLog Part 1
Blomker Mendelmax 1.5 3D Printer BuildLog Part 2
everything wrap up nicely now no more messy cable dangling around
printer still need some calibration, initial Slic3r setting seem close enough printing 20×20 cube yield 20.x result which is acceptable for me
here few thing that I have printed after the calibration,
Gopro 2 Naked mount (www.thingiverse.com/thing:25628)
Base Plate and if you notice it now attached to my front frame of the printer
www.thingiverse.com/thing:335179
a few micro quad arm (www.thingiverse.com/thing:158809)
MishaT Spool holder (www.thingiverse.com/thing:26472), bought the bearing from reprap.my,
attached nicely to the printer
Some Keychain made using thinkercad which have my HAM callsign 9W2DLR
XT60 battery cap, this was actually my first print and get me realize that my Y axis are inverted :p
Overall it a fun build and straight forward, I still waiting for my LCD controller so I don’t need to have my laptop connected to the RAMPS when printing which is sometime will take 12 hours!
I tried to print Zam Kossel part but 20 minutes before completion whole house when blackout! the print almost take 5 hours but failed at the end but I think I can still use the part
more to come, hopefully can do some video showing the printer printing
Stay tuned