Holy crap! literally CRAP! hopefully none of these made it into my hotend T_T
Cheap PLA from china
Cheap is not always good! at some part it even measured 1.98MM!!, plus seem this PLA have a very high melting temp, I have to run it at 210C which normally my previously spool I run at 190c
Repetier-Host Slic3r config
Request by my reader here is my Slic3r setting that I use with Repetier-Host
Repetier-Hosthttp://reprap.org/wiki/Repetier-Host
This is what I used to print this:
Slic3r Setting, only for the important stuff
Layer And Perimeters:
Infill
Speed
Advanced
last but not least my Extruder setting, this you need to probably fine tune to your printer
MendelMax 1.5 Calibration Part 2 + extra
Here is my final print,
10% infill 0.3 layer
100mm/s retract speed
3mm retract lenght
couldt be more happy with the result 
In addition to that I added a servo for auto bed leveling 
work quite nice I must say but problem is the servo is to far out to the front, I will need to print a new x-carriage so I can put the servo to the side so it can cover a lot more bed surface
MendelMax 1.5 calibration part 1
I updated my ramps to the latest version even tho setting are almost perfect but still having oozing issues as we can see on my test print result below, still need to play around with the extruder setting!
file: www.thingiverse.com/thing:9804
at least bridging are perfect!
ZMR/RCX 1804 X Mount 3D Print
need a mount? print them
