Holy crap! literally CRAP! hopefully none of these made it into my hotend T_T
Request by my reader here is my Slic3r setting that I use with Repetier-Host
This is what I used to print this:
Layer And Perimeters:
last but not least my Extruder setting, this you need to probably fine tune to your printer
Here is my final print,
10% infill 0.3 layer
100mm/s retract speed
3mm retract lenght
couldt be more happy with the result
In addition to that I added a servo for auto bed leveling work quite nice I must say but problem is the servo is to far out to the front, I will need to print a new x-carriage so I can put the servo to the side so it can cover a lot more bed surface
I updated my ramps to the latest version even tho setting are almost perfect but still having oozing issues as we can see on my test print result below, still need to play around with the extruder setting!
at least bridging are perfect!
Finally a fully functional Reprap 3D printer, got my crucial part for cleaning up my wiring which is a acrylic plate, cleaned up my wiring nice and tidy now :), for previous post
here few thing that I have printed after the calibration,
Gopro 2 Naked mount (www.thingiverse.com/thing:25628)
Base Plate and if you notice it now attached to my front frame of the printer
a few micro quad arm (www.thingiverse.com/thing:158809)
Overall it a fun build and straight forward, I still waiting for my LCD controller so I don’t need to have my laptop connected to the RAMPS when printing which is sometime will take 12 hours!
I tried to print Zam Kossel part but 20 minutes before completion whole house when blackout! the print almost take 5 hours but failed at the end but I think I can still use the part